北京桑普高能科技有限公司

汽车座椅加热系统 car seat heating system

一 综合说明 General information

此款产品是我们多年研究的结晶,在控制方面采用微电脑控制,温度任意调节,同时有30分钟定时功能.组成更为简单,只有两部分,由插到点烟器上的控制器和连体热片组成.发热部分采用高科技发热材料,升温快. This product is the result of our effort on researching and developing through many years, the control system is controlled by the micro-computer, the temperature is adjusting freely, with 30minutes timing function. The product is made by only two sections, the controller which is plug in to the cigarette-plug plus pads, the heating element is adopted by hi-tech heating material, with the character of temperature raising rapidly.

二 是您冬季的好伴侣 your best companion in winter season

在每年寒冷的冬季,它升温快,温度任意调节,使您的腰酸腿疼有一定的缓解作用,对健康者-有一定的保健作用,可避免因寒风的入侵所引发的疼痛.in every cold winter, this product will reducing your painful of your waist and back through its rapidly temperature-raising and temperature-adjusting, it healthy to the people, to live away from the painful caused by cold wind.

三 安装方法installation guide

1.将座椅的外座套取下,而后将发热片的背面双面胶撕开,再将发热片粘贴到座和靠背上,再把座套套好.贴热片时座和靠背粘贴时要成直角take out the outer cover of the seat, tear off the double-side sticky, stick the heating pad into the bottom and back from the seat, then re-cover the seat cover, it should be a 90degree angle while sticking the bottom and back

2.将加热体的电极引出线从座和靠背的中缝处放于座椅下面.put the extend wire from electrode at the bottom of the seat where the position of the seat and back

3.将温度控制器插到汽车点烟器的插座中.而后将控制器的插头和发热体的插座在座椅下方对接,这时座椅加温系统就安装好了.plug the temperature controller into the cigarette-plug, to connect the connector of controller with the connector of the heating pads under the seat, then the whole heating system is installed well.

四 使用方法users manual

1.将温度控制器的开关从细的符号方向向粗符号方旋转,这时电源灯和调温灯同时亮,红灯为升温工作灯,绿灯为电源灯.turn the switch of the temperature controller from thin-sign to the thick-sign, the indicator of power and temperature-adjusting will be light-on at the same time, the red-indicator mean temperature raising indicator, the green-indicator means power indicator.

2.调温开关上的温度指示符号越粗表示温度越高.即向粗符号方向旋转到某一位置不动后,表示把温度设定在此点上.the changes of thicker-sign of temperature indicator from temperature adjusting switch means raising the temperature steadily, the temperature will be set up wile you turn the switch to the thicker-sign and stay in a certain position.

3.如果在使用一段时间后发现温度较高,这时可向细符号方向旋转,将温度设定低一些.if you feel the temperature is higher after you using it for a certain time, to reduce the set up temperature by turning the switch to the thinner-sign.

4.如果要关掉加热系统,只需将调温开关旋到温度调节符号小处后即可,这时控制器上的灯全部灭掉.if you want switch off the heating system, just turn the temperature adjusting switch into the minimize of the sign, the indicator from the controller will be off at this time.